Description
NOT A DIY PRODUCT – BUILT AND TESTED BY 4MS IN PORTLAND, OR, USA
Row Power is a clean, regulated, and protected power solution for eurorack systems.
Row Power 35 provides 35W of power, suited for any typical eurorack single or double row (84HP to 168HP):
- +12V @ 1.4A
- -12V @ 1.25A
- +5V @ 1.0A
Simply plug a laptop style power supply into either of the barrel plugs on the 4HP panel. Connect your modules via flying-bus cables, or connect the Row Power to a Distro Board.
Daisy-chain multiple Row Powers to use a single power brick for multiple rows. Each row will be independently regulated and protected for ultra-low cross-talk between rows. Rows can also be hot-swapped (plugged/unplugged without powering the whole system down).
Row Power 35 – User Manual
SYSTEM EXAMPLES
For any system you need at least these four items
- One Row Power Module
- One Distribution device (BusStick or Flying Bus Cable)
- One PSU Brick
- One PSU Cord
Then optionally if you want to daisy chain multiple row power modules you need
- A Link Cable – DC Jumper – available HERE
EXAMPLE
A single / double row (84HP to 168HP) of Eurorack
- One Row Power 35 Module
- One Male Bus Cable
- One 90w PSU Block
- One PSU Cord (EU, UK or USA)
Row Power 35 Features
- Two power jacks for daisy-chaining multiple ROW POWERS: a common laptop-style power brick could power 3-5 rows (typical)
- On/off switch cuts power without interrupting the daisy-chain
- ROW POWER 35 provides more than enough power for a 84HP or 104HP row of modules.
- Ultra-clean: Each rail is separately regulated with high-grade components
- ROW POWER is efficient, so it won’t heat up your system.
- Skiff-friendly: only 27mm (1.1″) with power connectors installed.
- CV/Gate headers for expansion
All further technical questions related to the product should be sent to [email protected]
